THE LEADING ECONOMIZER SYSTEM INSTALLER
IN BANGKOK, THAILAND
" ECONOMIZER REDUCES FUEL CONSUMPTION IN THE PRE HEAT BOILER PROCESS AND REDUCE CO2 EMISSIONS INTO THE ATMOSPHERE "
THE LEADING ECONOMIZER SYSTEM INSTALLER
IN BANGKOK, THAILAND
" ECONOMIZER REDUCES FUEL CONSUMPTION IN THE PRE HEAT BOILER PROCESS AND REDUCE CO2 EMISSIONS INTO THE ATMOSPHERE "
What is the Economizer System ?
Economizer is an equipment used for capturing waste heat from Boiler exhaust. Boiler machine uses combustion of fuel and air to generate heat into mediums such as water, or thermal fluid. Heat is indirectly transferred into the medium and carried out through exhaust stack as new fuel and air mixture is heated. The amount of waste heat is varied with boiler efficiency and dew point of the exhaust air. Most of the exhaust air will have a temperature above 160 degree Celsius. This wasted heat can be used to pre-heat water feeded into the boiler and reduces its fuel consumption. With an economizer, boiler efficiency will be significantly increased.
Process of Installing Economizer System
Steam boilers generate steam by transferring heat energy from fuel combustion indirectly into the water and vaporize it. Fuel required oxygen within the air mixture to start a combustion. After the complete combustion, the by-product is a flue gas which contains a certain amount of leftover heat from the process. The waste heat is released out through the boiler's stack chimney. By installing an economizer, flue gas heat energy will be transferred into water. The water that has received the heat energy is then fed back into the boiler to reduce fuel consumption for further steam production.
There are two types of economizers:
- Round Chimneys
- Square Tubes.
In general, the heat recovery of the flue gas from the boiler to preheat the feed water increases the thermal efficiency of the boiler by approximately 1% for every 30 ° C of the recoverable flue gas temperature. Thus saving the fuel required for the boiler. The flue gas of the boiler can reach a temperature of about 200 250 ° C at full load. In this case, the wasted heat With this flue gas can be up to 20%, therefore adopting an economizer to reduce the boiler energy consumption is an efficient method of energy saving. An economizer will not be able to do this. If the temperature of the flue gas after passing Economizer is too low because it will affect the draft force and may cause sulfur condensation in case the fuel used in the boiler is high. The sulfur is contaminated. This will cause corrosion to metal equipment, the temperature at which the condensation will depend on the amount of sulfur present in the fuel. And can be considered as one of the limitations in the design.
Economizer, the considerations for assessing the heat energy available in flammable gas and applied by the heat exchanger between Gas and liquid, or The economizer has to be considered in terms of quality. And the amount of heat lost Then should take into account The dew point temperature of the sulfuric acid, which is caused by the sulfur-containing fuel. For fuels containing sulfur components, the exhaust temperature is not lower than 180 degrees Celsius.
What is the Economizer System ?
Steam boilers generate steam by transferring heat energy from fuel combustion indirectly into the water and vaporize it. Fuel required oxygen within the air mixture to start a combustion. After the complete combustion, the by-product is a flue gas which contains a certain amount of leftover heat from the process. The waste heat is released out through the boiler's stack chimney. By installing an economizer, flue gas heat energy will be transferred into water. The water that has received the heat energy is then fed back into the boiler to reduce fuel consumption for further steam production.
There are two types of economizers:
- Round Chimneys
- Square Tubes
In general, the heat recovery of the flue gas from the boiler to preheat the feed water increases the thermal efficiency of the boiler by approximately 1% for every 30 ° C of the recoverable flue gas temperature. Thus saving the fuel required for the boiler. The flue gas of the boiler can reach a temperature of about 200 250 ° C at full load. In this case, the wasted heat With this flue gas can be up to 20%, therefore adopting an economizer to reduce the boiler energy consumption is an efficient method of energy saving. An economizer will not be able to do this. If the temperature of the flue gas after passing Economizer is too low because it will affect the draft force and may cause sulfur condensation in case the fuel used in the boiler is high. The sulfur is contaminated. This will cause corrosion to metal equipment, the temperature at which the condensation will depend on the amount of sulfur present in the fuel. And can be considered as one of the limitations in the design.
Economizer, the considerations for assessing the heat energy available in flammable gas and applied by the heat exchanger between Gas and liquid, or The economizer has to be considered in terms of quality. And the amount of heat lost Then should take into account The dew point temperature of the sulfuric acid, which is caused by the sulfur-containing fuel. For fuels containing sulfur components, the exhaust temperature is not lower than 180 degrees Celsius.
Process of Installing Economizer System
Steam boilers generate steam by transferring heat energy from fuel combustion indirectly into the water and vaporize it. Fuel required oxygen within the air mixture to start a combustion. After the complete combustion, the by-product is a flue gas which contains a certain amount of leftover heat from the process. The waste heat is released out through the boiler's stack chimney. By installing an economizer, flue gas heat energy will be transferred into water. The water that has received the heat energy is then fed back into the boiler to reduce fuel consumption for further steam production. There are two types of economizers: one for round chimneys and one for square tubes. In general, the heat recovery of the flue gas from the boiler to preheat the feed water increases the thermal efficiency of the boiler by approximately 1% for every 30 ° C of the recoverable flue gas temperature. Thus saving the fuel required for the boiler. The flue gas of the boiler can reach a temperature of about 200 250 ° C at full load. In this case, the wasted heat With this flue gas can be up to 20%, therefore adopting an economizer to reduce the boiler energy consumption is an efficient method of energy saving. An economizer will not be able to do this. If the temperature of the flue gas after passing Economizer is too low because it will affect the draft force and may cause sulfur condensation in case the fuel used in the boiler is high. The sulfur is contaminated. This will cause corrosion to metal equipment, the temperature at which the condensation will depend on the amount of sulfur present in the fuel. And can be considered as one of the limitations in the design. Economizer, the considerations for assessing the heat energy available in flammable gas and applied by the heat exchanger between Gas and liquid, or The economizer has to be considered in terms of quality. And the amount of heat lost Then should take into account The dew point temperature of the sulfuric acid, which is caused by the sulfur-containing fuel. For fuels containing sulfur components, the exhaust temperature is not lower than 180 degrees Celsius.
Benefits of Installing Economizer
Economizers help reduce the temperature difference between the water in the pot and the vitreous. It also reduces the thermal stress on the drum. After installing an economizer, an exhaust temperature is reduced by approximately 20 degrees Celsius, which can increase a boiler efficiency by about 1%. For economizers, a safety valve and a temperature gauge must be installed separately.
Installing Economizer with Less to No Maintenance
An economizer is a gas-liquid heat exchanger. The device’s heat exchanger requires a regular cleaning at its surface since dirt from use may cause heat exchanger to be less efficient. The economizer can be cleaned easily by using water spray and scrubbing brush to clean and remove dirt.
Benefits of Installing Economizer
Economizers help reduce the temperature difference between the water in the pot and the vitreous. It also reduces the thermal stress on the drum. After installing an economizer, an exhaust temperature is reduced by approximately 20 degrees Celsius, which can increase a boiler efficiency by about 1%. For economizers, a safety valve and a temperature gauge must be installed separately.
Installing Economizer with Less to No Maintenance
An economizer is a gas-liquid heat exchanger. The device’s heat exchanger requires a regular cleaning at its surface since dirt from use may cause heat exchanger to be less efficient. The economizer can be cleaned easily by using water spray and scrubbing brush to clean and remove dirt.
Precautions for Economizer that makes us the Professional in Installer
When using a fuel containing sulfur, if the temperature of the exhaust gas is too high, there will be condensed sulfuric acid on the surface of Economizer and will cause corrosion (Low temperature corrosion). Thus, users must be careful not to let water enter the Economizer with too low temperature. An economizer has been recently used in various machines and equipment for the production process. This will allow industries to use their existing energy more efficiently. This means that heating and cooling systems take advantage of alternative energy sources such as wind or solar collection systems and some types of heat exchangers that improve the overall performance of HVAC equipment or climate systems.
Precautions for Economizer that makes us the Professional in Installer
When using a fuel containing sulfur, if the temperature of the exhaust gas is too high, there will be condensed sulfuric acid on the surface of Economizer and will cause corrosion (Low temperature corrosion). Thus, users must be careful not to let water enter the Economizer with too low temperature. An economizer has been recently used in various machines and equipment for the production process. This will allow industries to use their existing energy more efficiently. This means that heating and cooling systems take advantage of alternative energy sources such as wind or solar collection systems and some types of heat exchangers that improve the overall performance of HVAC equipment or climate systems.
คุณไกรสร พิทยรังสฤษฎ์
( เจ้าของกิจการ )
" ติดตั้ง Heat pump ปี พ.ศ 2555 มีการซื้อ Service รายปีตั้งแต่ปีที่ติดตั้งระบบ ระบบดูแลไม่ยาก เปิดใช้งานได้สะดวก ทีมช่างทำงานดี ตรงต่อเวลา "
คุณกฤช โล่ทองคำ
" ติดตั้งระบบผลิตน้ำร้อนพลังงานเหลือทิ้งจากแอร์ ตั้งแต่ปี พ.ศ 2556 ปัจจุบันระบบก็ยังใช้งานได้ดี ระบบดูแลง่าย ไม่ยุ่งยาก ซึ่งนอกจากได้น้ำร้อนมาใช้ฟรีๆแล้ว ยังช่วยประหยัดค่าแอร์อีกด้วย "
คุณยรรยง ลิ้มพาณิชย์
" ติดตั้งระบบผลิตน้ำร้อนพลังงานแสงอาทิตย์ปี พ.ศ. 2561 การติดตั้งระบบไม่มีปัญหาเลย เป็นการใช้ประโยชน์จากพลังงานแสงอาทิตย์มาใช้ได้อย่างดีเยี่ยม ทีมช่างทำงานตรงตามกำหนดการเวลา ทำงานเรียบร้อย และฝั่งออฟฟิศประสานงานได้ดีมาก "
คุณอติชาติ
" Feedback ติดตั้งระบบผลิตน้ำร้อนพลังงานแสงอาทิตย์ การเข้ามาบริการ Service ดีมาก เวลาระบบมีปัญหาหรือขัดข้องก็รีบเข้ามาแก้ไขได้อย่างทันท่วงที จนระบบกลับมาใช้งานได้ตามปกติ ซึ่งถ้ามีการหมั่นตรวจเช็คระบบอยู่เรื่อยๆ ระบบก็จะมีอายุการใช้งานได้อย่างยาวนาน "
Special
special privileges and spare parts discounts are available up to 25%.
Skilled
Technician team is skilled and experienced for more than 40 years
Quality
Quality materials can be used for more than 100 years.
Consultation
Please contact us. We are happy to advise you for a free energy saving guide
Innovative Energy Co., Ltd. (Sorarus) was founded in 2016 by a visionary Norwegian, Israeli, and Thai engineer and investors which acquired knowledge and skills from Israel, Germany, United States of America, and Thailand to provide a reliable system combining with a high quality service.
Innovative Energy Co., Ltd. (Sorarus) was founded in 2016 by a visionary Norwegian, Israeli, and Thai engineer and investors which acquired knowledge and skills from Israel, Germany, United States of America, and Thailand to provide a reliable system combining with a high quality service.
CONTACT US
- 228/11-12 Phaholyothin
Anusawaree, Bangkhen
Bangkok 10220
Copyright © 2021 Innovative Energy Co., Ltd.